We need to use a new type of vibrating screen in the over-flushing of our sand making and sand making. Today, we will introduce the feeding problem of the equipment.
The feeding speed of the screening material should match the processing capacity of the equipment. Too much feed at one time will hinder the normal movement of materials on the screen surface, make the screen fatigue and relax, reduce the service life of the screen, and greatly affect the processing capacity of the material. After achieving uniform feeding, users should also understand the operating thickness standards of different materials on the screen surface. The greater the thickness, the lower the screening accuracy, but the greater the output. The thinner the thickness, the higher the screening accuracy, but the smaller the output. These problems have always existed on the vibrating screen. Therefore, under the premise of uniform feeding, grasping the relatively good operating thickness of the material is an important sign of a better state of the vibrating screen. Under normal circumstances, the thickness of the material is required to be between 1-5 cm, and the user needs to follow the characteristics of the material Perform screening to obtain a better screening effect.
If the feeding amount at one time is too large, the load of the motor during balanced operation will suddenly increase, causing damage to the motor and reducing the service life of the motor. The feeding method with strong impact force needs to be equipped with a buffer hopper. The direct impact of the material on the screen surface not only consumes the exciting force generated by the vibration source, but also easily causes damage to the screen surface and fatigue of the screen, thereby affecting the output and quality of screening and filtration.
Then we will introduce to you the new rotating vibrating screen changing method:
1. Put the Pu ring and the bouncing ball on the punching board
2. Put the net frame (with mother net) on the punching board
3. Take out the tension net ring and loosen the clamping screw slightly to cover it on the net frame
4. Lay the subnet (fine net) on the bus and adjust the position
5. Place the clamp on the edge of the main net, tighten the ring net, tighten the clamping screws, and fix the secondary net
6. Remove the excess filter and turn the edge of the filter upwards
7. Install the rubber ring
The screen is the main consumable of the new vibrating screen, and it needs to be prepared as a spare. The replacement method is relatively simple. If you need, you can contact me, and we will introduce you to the product model that suits you. We can also customize the product according to your needs. We have product use videos for you to use.